How To Crimp Straight Hair

Download Article

Coaxial cable, commonly referred to every bit coax, is an electronic indicate wire used for signals that are sensitive to interference past outside dissonance sources. For example, lightning, articulate air static, motors and high frequency electronic signals could impose themselves on the wire and corrupt the point. Coax guards confronting this by wrapping a unmarried conductor with a tube of metal foil and mesh. This tube runs coaxially over the betoken usher. Maintaining the integrity of this shielding tube requires a special crimp termination method for coax. Use these tips to acquire how to crimp coax.

Steps

one
Create a termination point.
- Cut off the end of the coax. Use pocket-sized, sharp wire cutters. Create a squared off surface, rather than a beveled surface.
- Mold the terminate of the coax using your fingers. The cylindrical cablevision will be distorted by the pressure level of making the square cutting. Mold the terminate of the cablevision dorsum into a cylinder.
2

Insert the coax into a coax stripper tool. These tools are available at hardware and electrical stores. Make sure that the end of the coax is flush against the wall or guide on the stripping tool. This volition ensure proper strip length.

Advertisement
3

Clamp the stripper tool closed effectually the coax. Smoothly spin the tool around the coax iv or 5 times, or until you no longer hear the audio of metal being scored. Proceed the rotation in 1 place on the cable. Do not apply any force that would pull on the cable insulation coating.
4

Remove the coax stripper tool. The tool will have fabricated 2 cuts. Use your fingers to gently pull off the material nearest the finish of the cable. This volition expose the blank center conductor. Use your fingers to gently pull off the outer insulation that has been cut free. This will betrayal a layer of foil.
5

Tear off the exposed foil. This will expose a layer of metallic mesh.
half dozen

Bend dorsum the exposed metal mesh with your fingers. Do not tear the layer of foil that is nether the metal mesh. The foil must be left in place around the inner insulation. Curve the mesh all the manner back so that it is molded over the terminate of the outer insulation.
7

Printing the stop of the coax into the back of an F connector. F connectors are available at hardware and electrical stores. Make sure that the white inner insulation can exist seen pressing against the front flange of the connector. If you can't see the insulation, jiggle and proceed to push the coax and the connector together. Use directly force per unit area only. Do non twist the coax in the body of the connector.
viii

Crimp the connection. Place the F connector into a coax crimping tool. Coax crimping tools are bachelor at hardware and electrical stores. Fully squeeze the tool handle and release. Remove the finished crimp connection from the tool.

Advertising

Add New Question

Question

What is the length of the insulation I need to remove from the finish of the cable?

If information technology is a normal wire, and so maybe 1/2 inch.